SMT Cylinder And Sensor will be for sales
Smt Cylinder and sensor includes serveral brands,original and new, stable function, in stock
Juki Sensor
Juki Laser Sensor
Juki Smt Sensor
Laser Sensor
Juki Cylinder
Juki Square Cylinder
Juki Air Cylinder
Cylinder Square
Square Cylinder
SMT Cylinder And Sensor Air Cylinder,Smt Cylinder,Smt Sensor,Original Cylinder Shenzhen Srisung Technology Co.,Limited , https://www.sr-smt.com
When the LED display is in use, it sometimes appears garbled, causing the display to not work properly. Generally, garbled situations occur. You can find the reasons from the following aspects.
1. Software or control card problem
Garbled phenomenon may be that the LED display parameters are not set, this time you need to determine the scan configuration problem, usually 1/4 scan; if it is not a software problem, check the control card for problems; if these tests are no problem If you can, you can contact the service provider to solve it.
2. Cable problem
In the case of eliminating the power supply problem, the power supply of the test module is normal (if the abnormal first block has a dark 80%, there is a problem with the power supply).
3. Water leakage into the water problem
First of all, the garbled situation is mostly related to the leakage of the display screen. Because the rainproof and waterproof measures are not appropriate, it is likely that there will be water immersion after the rain, causing the circuit board to be short-circuited, and then garbled. If this happens, it is recommended to contact the supplier or repair shop immediately for repair.
4. Transfer data problems
The control circuit of the computer output to the LED display is faulty, and the display power and signal input sections are mainly checked. If the control system board is damaged, the data line interface is damaged, the data line is damaged or reversed, etc., the display will be garbled.
The garbled phenomenon is a common problem of LED display. If you encounter such problems, don't be nervous. Check the above reasons. If the problem has not been solved, please contact the factory as soon as possible.