introduction Siemens S7-1500 is Siemens's most powerful and cost-effective PLC so far. It has attracted the attention of our customers. Today we share with you some advantages and spectrums of Siemens Siemens S7-1500 and S7-300, S7-400 phase PK. Control. No.1 First of all, its design is more humane, and it is easier for engineers to accept it when it is selected. The S7-1500 module is slightly larger than the S7-300, and the rack is similar to the S7-300. The front connector has a wiring position when it is installed, and provides dedicated power supply components and shield brackets and line cards to make the wiring easier and more reliable. High; especially for engineers is the CPU is equipped with LED display, can easily display CPU status and fault information. No.2 Secondly, from the hardware point of view, the S7-1500 PLC has a faster processing speed, a stronger networking capability, and a higher diagnostic capability and safety. It not only saves costs, increases production efficiency, but also is safe, reliable, and easy to maintain. It truly becomes a factory. The preferred controller for customers and field maintenance personnel. For example, compared to S7-300/400, S7-1500 PLC adopts new backplane bus technology, adopts high baud rate and high transmission protocol to make its signal processing faster; S7-1500 all CPUs integrate 1-3 The PROFINET interface enables low-cost and rapid configuration of field-level communications and corporate network communications, while the S7-300/400 PLC only integrates the PROFINET interface with individual CPUs; the module of the S7-1500 PLC integrates diagnostics and the diagnostic level is channel-level. No additional programming is required. When a fault occurs, the affected channel can be quickly and accurately identified, reducing downtime. This is unmatched by the S7-300/400 PLC. No.3 The configuration and programming efficiency of the S7-1500 PLC is more readily accepted by the engineering site personnel. The S7-1500 module is slightly larger than the S7-300, and the rack is similar to the S7-300. The front connector has a wiring position when it is installed, and provides dedicated power supply components and shield brackets and line cards to make the wiring easier and more reliable. High; especially for engineers is the CPU is equipped with LED display, can easily display CPU status and fault information. No.2 Second, from the hardware point of view, the S7-1500 PLC has faster processing speed, stronger networking capability, and diagnostic capabilities. The S7-1500 PLC supports a wider range of data types than S7-300/400 PLCs. The basic data types of S7-1500 PLC are up to 64 bits in length, while the basic data types supported by S7-300/400 PLCs are up to 32 bits in length; S7-1500 PLC supports Pointer, Any, and Variant, and S7-300/ 400 PLC only supports the first two. These features make the programming of the S7-1500 PLC more flexible. No.5 In addition, the S7-1500 PLC can implement motion control without using other modules. With PLCopen technology, the controller can use standard components to connect various drives that support PROFIdrive; in addition, the S7-1500 PLC supports TRACE functions for all CPU variables, improving commissioning efficiency and optimizing the performance of the drive and the controller. summary In short, the functions of the S7-1500 PLC cover not only the vast majority of S7-300/400 PLCs, but also have a wide range of applications and a wide range of applications, combined with its unparalleled advantages, making it a must for future development. Widely used in various engineering fields. S7-300 and 1500 models Data Acquisition Digital Potentiometers Shenzhen Kaixuanye Technology Co., Ltd. , https://www.iconlinekxys.com
