The explosion-proof vibration motor should be firmly mounted on the vibration machine and must not be loose. After the first use, the anchor bolts should be re-reinforced. Twinkle System Technology Co Ltd , https://www.pickingbylight.com
The rubber sleeve soft cable (outer rubber outer diameter 15mm) of the explosion-proof vibration motor is connected with the power supply. The wiring steps are as follows:
a. Wipe the outside of the junction box and peel off the insulation of the cable.
b. Remove the cable gland, cable guide sleeve, seal ring, and junction box cover.
c. Put the cable gland, cable guide sleeve and sealing ring on the cable, then connect the power core wire and grounding wire of the cable to the terminal and the grounding screw respectively, and pay attention to the exposed part of the wire not to be exposed outside the bow washer.
d. Install the sealing ring, cable guide sleeve, outlet pressure plate and junction box cover.
e. Disassembly and disassembly should pay attention to protect the explosion-proof surface from damage. When assembling, apply 204-1 anti-rust oil. After installation, the explosion-proof surface should be tightly fitted.
The cable must have a natural overhang between the junction box and the non-vibrating fixed card, that is, the cable length between the junction box and the non-vibrating fixed card should be 400-700 mm longer than the line distance.